
When you use the AC adapter to connect your xTablet T1200 to a power outlet,
the internal battery packs will automatically begin to recharge. While the battery
pack is charging, the Battery Charge icons on the LED indicator panel will
be active after 6 to12 seconds:
• Blinking Red – battery power is at slow-power (critical) state - time to recharge
•
Steady Orange – battery pack is charging
•
Steady Green – battery pack is fully charged
Upper left corner of front view of the xTablet T1200 with the LED Indicators – the Battery Status
icons are #2 and #3.
1. Power indicator
2. 1
st
Battery status indicator
3. 2
nd
Battery status indicator
4. Built-in hard disk indicator
5. WLAN or Bluetooth indicator
Note: The xTablet T1200 can run on both fully-charged Lithium Ion batteries
for 8 to 10 hours with the Hi-Brite LCD panel, or 10 to 12 hours with
standard LCD panel.
If your xTablet T1200 is turned off, the fully-discharged batteries will take about
three hours per pack to recharge. Refer to the following:
Replacing the Battery Pack
Over time, battery pack capacity gradually decreases. MobileDemand
recommends that you replace your battery packs when you notice that they begin
to store significantly less charge.
To replace the battery pack
1. Turn off the xTablet T1200.
2. P r e s s a n d h o l d t h e b a t t e r y l a t c h r e l e a s e b u t t o n , a n d s lide the
latch to the UNLOCK position to release the depleted battery pack
3. Lift the depleted battery pack out of the compartment and remove it from
tray.
4. Align the replacement battery into the battery compartment.
5. Push completely until battery locks into place, and slide the latch to the
LOCK position to secure the battery.
T1200
Rugged Tablet PC
Quick Start Guide
Questions? Call MobileDemand Support at
877-784-4338.
Copyright © 2010 MobileDemand,
LC.
All Rights
Reserved.
Kommentare zu diesen Handbüchern